AEKE K1 keeps tripping the breaker? What to do
Stop using the K1 and contact AEKE Support. Don't keep resetting the breaker to test it, and don't bypass the breaker, remove the ground pin or use an adapter. Tell us whether it trips when you plug in, at power-on or after the K1 has been running.
Stop and stay safe
- Don't reset the breaker over and over to test the K1.
- If you notice unusual noise, a smell or smoke, turn off the power, unplug the cord if it's safe to do so, and contact us.
- Don't bypass a breaker, remove the ground pin or use an adapter to get around an outlet's protection.
Check the basics
- Use the original power cord that came with the K1.
- Plug into a safety-certified, grounded wall outlet and avoid overloading the circuit.
- Plug directly into the wall rather than a power strip or extension cord.
Note when it trips
Tell us whether the breaker trips as soon as you plug in, a few seconds after the K1 powers on, or after it has been running for a while. Use what you've already seen; there's no need to trigger it again.
Still not fixed?
Contact us with the details below. Our team will review your case and tell you the next step.
Please include:
- Order number
- Serial number (SN)
- Your country or region
- When the breaker trips (plug-in, power-on or while running)
- The breaker or outlet type, if you know it (don't open the panel to check)
If a fault could be unsafe, don't repeat it just to record a photo or video; send what you already have.
